The ice axe is a multi-purpose snow tool. It gives you support when you walk, helps you cut steps, can serve as an anchor, and, most importantly, can stop you if you slide. Self-arrest is the skill that matters most. It is an insurance policy, not a plan. Good footwork and route choice prevent most slips, and self-arrest is what you rely on if one happens anyway. Learn the basics before you need them.
Parts of an ice axe
- Head. Usually steel, with the pick and adze on either end and a hole for a leash.
- Pick. The sharp, usually curved, end of the head. It bites into snow and ice, and it is the part you drive in during self-arrest.
- Adze. The flat, hoe-like end, used to cut steps and seats in snow and ice.
- Shaft. Straight shafts suit general mountaineering, and they can be used as a support cane on gentle ground. Curved shafts give more clearance from the snow on steeper terrain.
- Spike (or ferrule). The sharp point at the bottom of the shaft. It provides support when you walk, and it plunges into snow for a belay or a rescue.
- Leash and leash stop. Optional accessories that keep the axe attached to your wrist, and stop the leash slipping off the shaft.
Choose the right length
For general mountaineering, shorter axes are common. Many climbers use axes around 45 to 60 cm (18 to 24 in), and axes longer than about 60 cm are generally seen as too unwieldy for cutting steps or climbing steep snow.
A traditional way to check length is to hold the axe by the head, with the spike on the ground, while standing relaxed. The spike should barely touch the ground. This method is still used for flatter terrain, such as glacier travel.
Carrying and walking
On snow, carry the axe in your uphill hand. Hold it by the head, and use the spike like a walking stick for balance. On steeper ground, drive the shaft into the snow for extra support. When the route changes direction across a slope, plant the axe firmly, take it in both hands, turn, and move it to your new uphill hand.
Keep the axe ready before you reach the difficult ground. Pulling it out after you have started to slide is too late.
Grips: self-arrest and self-belay
There are two basic grips.
Self-arrest grip. The pick points backward, and the adze points forward. Wrap your thumb under the adze, and place your other fingers over the pick. Your hand is already in position if you slip. The trade-off is that you cannot easily drive the pick into steep snow while you walk.
Self-belay grip. The pick points forward. Place most of your palm over the adze, with your thumb and forefinger wrapping under the pick. This gives extra security on steeper ground, because you can drive the pick into the slope while standing. It takes practice to turn the axe into the self-arrest position from this grip, because the head has to rotate.
The leash decision
A leash keeps the axe from being lost in a fall, but on steep or high-consequence ground it can become a hazard. Think about how likely you are to drop the axe, and what happens if you do. If you use a leash, attach it to your wrist, not your harness. A harness attachment is too close to your body, and a fall with the axe tied to it could cause serious injury.
Using a leash means you have to move it to the other wrist every time you turn, because the axe must stay in your uphill hand. This slows you down and can add risk. On low-consequence ground, many climbers travel without one.
Dagger and self-belay positions
Once you are comfortable carrying and walking, you can learn the positions used to secure yourself on steeper snow. These are more advanced, and they are best learned with an instructor.
- Low dagger (piolet panne). Press the pick into the slope at about waist level, with your palm on the top of the adze. This is quick and useful for downclimbing, but it feels less secure than the other positions.
- Middle dagger (piolet appui). Hold the shaft just below the head, and push the pick into the slope with more force.
- High dagger (piolet poignard). Hold the head, reach high, and place the pick in the snow. This often gives better security on very steep slopes.
- Self-belay or deep plunge (piolet manche). Drive the axe straight down as far as it will go, and keep a hand on the head. In soft snow, both hands on the head can be stable. On harder snow, one hand on the head and one on the shaft near the snow gives more control against a slip.
Self-arrest: the basic sequence
Self-arrest works best when you act at once. The longer you slide, the faster you go, and the harder the stop becomes.
- Act immediately. Start the arrest as soon as you realize you are sliding.
- Get the pick into the snow. Bring the axe head to your chest or shoulder, with the pick angled down toward the snow. Drive the pick in, and keep your other hand on the lower shaft.
- Lean into the axe. Put your chest and shoulder over the head of the axe, and press down with your weight.
- Lift your feet. Lift your legs and feet off the snow so the crampons do not catch and trip you.
- Stop and get your feet under you. Once you slow down, dig your toes or crampon points into the slope, so you finish with your feet downhill and facing the slope.
Keep the axe under you when you stop, and do not let go of the head.
Self-arrest from four fall positions
The starting position changes the arrest, but the goal is the same: use your body and the axe to stop, and finish with your feet downhill.
- Fall on your stomach, head uphill. This is the easiest, because you are already in the right orientation. Drive the pick in, bring the shaft close to your torso, and lift off the snow.
- Fall on your back, head uphill. Roll toward your uphill hand, which holds the head of the axe. Face the snow, then set the pick and get into the arrest position.
- Fall on your back, head downhill. As you slide, plant the pick at your side. Keep your eyes on the axe as you twist, so your feet come around to the downhill side.
- Fall on your stomach, head downhill. As you slide, reach out and plant the pick. Swing your body so your feet end up downhill.
Practice safely
Practice is the only way to make self-arrest reliable. Use these guidelines.
- Practice on a gentle, short slope of firm snow, with a clear runout, free of rocks, trees, and cliffs.
- Learn the grips and the arrest without crampons first. Add crampons once you are confident, because they can catch and make the arrest harder.
- Practice from all four fall positions, and practice getting the axe out of your pack quickly.
- Take a course with a qualified instructor. A good course will give you feedback you cannot get from reading.
For how the axe fits into a complete snow kit, see the crampon guide and the gear checklist. The alpine climbing basics article covers how these skills fit into the wider process of learning to climb mountains. If you are planning a first big snow climb, the beginner’s guide to Mount Hood lists the skills to have before you go.